Dave,
The screws for your BN7 alloy trim plates were not Posi-drive until the BJ8.
The BN7 would have Phillips heads with the slight ringed flange around the
edge of the head. Shank was small, probably a number 4 self tapping, and
they were not countersunk but set onto the surface of the trim plates.
Meanwhile the Hundreds used Number 6 self tapping countersunk screws with
slightly domed heads. These are carefully countersunk into the surface of
the alloy plates.
Rich Chrysler
----- Original Message -----
From: "David Malaney" <61healeybn7@gmail.com>
To: <healeys@autox.team.net>
Sent: Saturday, April 12, 2008 1:23 PM
Subject: [Healeys] door shut face finisher fasteners
> Can someone remind me what fasteners are used on the door finish pieces.
>
>
> Thanks,
> Bill
> BN7
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler@quickclic.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|