Wayne -
Usually you can turn the head upsid down and there's a little
ractangular notch about 1/2" long on the side of the head towards the
front I think. If that notch is about 1/8" deep from the head surface
you are ok, if the notch is very shallow it means your head's been
milled.
Alan
On 4/12/08, Wayne <Waschu2@charter.net> wrote:
> HI,
>
> Does anyone know the head thickness for a 3000 head? I have a
> 3000 head that has previously been milled and it has now warped and
> blown the head gasket. It has a low spot from around cylinders 2 and 3
> to the spark plug side of the head. It was bubbling slightly around #3
> spark plug when hot. The leak seemed to be more compression then
> antifreeze as the antifreeze level never went down and there where never
> bubbles in the radiator.
>
>
> Thanks
>
>
> Wayne Schultz
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as healey.nut@gmail.com
>
> http://www.team.net/archive
>
--
Alan
'52 A90
'53 BN1
'64 BJ8
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|