Hi everyone, I need some advice. The front throttle lever on my tricarb--the
carb coupling shaft--has a little play ( the rod moves relative to the
vertical flat part). The rear one is tight. What is the easiest/most effective
way to remedy this? I have thought of solder/spot weld/JB weld--what will
work?
By the way, I have the carbs removed/balance tube off /linkages
disassembled, so I have the piece loose for easy repair
Thanks
Bruce Starke
Golden BC
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|