Jerry,
Sounds like you haven't been there before. Some of the fender bolts won't be
accessible from the fender side only. There's an inner wheel arch in the
way, unless you can hire a fellow with arms and fingers like E.T. Also that
would mean installing the clips onto the shroud flange which for most of the
length has a J shaped flange running along the bottom edge.
Front shroud on or off is optional but easier with it off.
----- Original Message -----
From: "Jerry Costanzo" <grumpyinloomis@ssctv.net>
To: <healeys@Autox.Team.Net>
Sent: Friday, March 28, 2008 9:18 PM
Subject: [Healeys] Fw: I wish I would have done this before I put the engine
in?
>> No 2a, 5, 6, 7 are done. I have never tried putting the inlet and
>> exhaust on prior to having the engine installed. Might be worth trying.
>> Would you install the engine prior to putting on the front shroud? I
>> am
>> hoping to set up all the fender bolts so they can be accessed from the
>> fender side, not the engine side.
>>
>> Gearbox is going in with the engine. I have done them separate and that
>> is no fun.
>>
>> 10. sounds good
>> 11 has beer involved, that does not taste good, but I will substitute.
>> 12. I can hardly wait.
>>
>> Jerry
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler@quickclic.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|