I have an old belt-driven, squirrel-cage blower with attached motor from a
1950's era furnace. I think it would make a great shop/garage air mover.
Question: Is it possible to construct a multi-position speed control for
this blower? For example, low-high, or low-med-high. The drive motor has
the following specs:
Two-wire (power and neutral), 1/4 HP, single-phase, 1275 rpm, 115V, 4.6A, 60
Hz, continuous duty, frame 56.
Any suggestions or help would be appreciated.
Thanks.
Tom Rech
59 BT7
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|