Hi Everyone
I am in the process of installing a new king pin on my BJ7. I Want to
know the amount of end clearance that is required. I have measured mine with
new king pin and bushings installed and is about 22 thou with a feeler gauge
I believe this is to much ??? Does anyone on the list know the amount of
clearance that there should be ??? Can I then built up the trust washer with
shim stock to take up the end play ??
Bob
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|