Rich,
Thanks. I'll go measure the two that I have. I'm guessing the
measurement is taken with the shaft retracted.
Mike
Rich C
> Hi Mike,
>
> The earlier BN1 to car 140204 had a driveshaft 21 1/8" long.
> The next one from car 140205 to 221535 was 20 3/4" long.
> The last one, for all Hundreds from BN1 car 221536 through end of BN2 was
> 20" long. These were the cars with the C series rear axle, therefore
> slightly longer diff nose.
>
> Rich Chrysler
>
> ----- Original Message -----
> From: <rrengineer@dslextreme.com>
> To: <healeys@autox.team.net>
> Sent: Friday, January 18, 2008 8:47 PM
> Subject: [Healeys] BN1/BN2 Driveshaft
>
>
>> What is the difference between a BN1 and a BN2 driveshaft? I would
>> like
>> to find out if I have the wrong one for my restoration.
>> Mike MacLean
>> 56 BN2
>> 60 AN5
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|