[Healeys] question on connecting rods

["Jerry Costanzo" <grumpyinloomis@ssctv.net>]

My machinist was re-sizing the big ends of my connecting rods and found that 3
of them were way out of round.  He does not see that very often.  The crank is
still at std specs.  What would cause the big end of the rods to wear
un-evenly?

Jerry
BJ8
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys

http://www.team.net/archive