Hi Gary,
I am also currently assembling a Phase 1 BJ8. These early "behive" style
glass lens sidelamps seem to have the same harness arrangement as the
earlier roaadster and BJ7 cars. That is the 3 PVC coated wires come out of
the back of the lamp boot and are braided together with a thin band of tape
wrap every 10" or so. The harness tucks back onto the side of the rubber
boot and is held there with a rubber O ring rolled over the boot body and
the harness. The harness then goes inboard past the splash shield and up to
it's respective connectors.
Rich Chrysler
----- Original Message -----
From: <Warthodson@aol.com>
To: <healeys@autox.team.net>
Sent: Saturday, December 22, 2007 9:42 AM
Subject: [Healeys] side lamp harness
>I need some help understanding the details of the wiring harness that feeds
> the parking/turn signal lamps on a BJ8 phase 1.
> First, I assume the wires are PVC, but I can't figure out if the covering
> was
> cloth or PVC, if any covering. If cloth, was there a color trace? Is the
> correct harness available somewhere?
> Thanks,
> Gary Hodson
>
>
>
> **************************************See AOL's top rated recipes
> (http://food.aol.com/top-rated-recipes?NCID=aoltop00030000000004)
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|