Okay, here is my final summary of this topic.
I heard from a number of folks, several of whom I consider to be
Healey "authorities." There was a split decision as to whether the
front securing fastener on the aluminum moulding is a #10 machine
screw with nut, or a #10 sheet metal screw. My guess is that
originally the car had sheet metal screws in this location.
However, in my case, and I suspect in many others, the hole in the
shroud for the sheet metal screw was enlarged over the years to the
point that a #10 screw will no longer tighten down. Going to a #12 to
solve the problem results in a screw head that is much too large for
the moulding hole and it would not match the other machine screws in
the moulding.
I love this the Healey fraternity because people are so willing to
help. Jack Brashear came up with what I consider to be the best
solution to this issue. Getting a regular nut on the back of the
securing screw is virtually impossible. Good luck, too, getting any
kind of wrench on the nut to hold it while tightening the screw!
Jack's suggestion was to us a Kep's nut (it has a star lock washer
attached to it) to secure a #10 x 1/2" or 5/8" machine screw. See the
photos (click on the thumnail for larger image) at the following web
site:
http://homepage.mac.com/linwoodrose/PhotoAlbum60.html
As Jack suggested, I stuck the Keps nut on the end of a hacksaw blade
with some 3M rope caulk, being careful not to get the caulk in the
threads of the nut. I used a 5/16" nut on the back side of the blade
to act as a spacer and slid the blade with nuts behind the moulding
and shroud lip. You can visually line up the holes and insert the
screw, turning carefully until it engages. You might need to hold a
flat blade screw driver against the nut until it gets tight enough for
the teeth on the washer to grab hold. The hack saw blade was the key -
nothing much thicker than the blade will work in the limited space
available. That is why I think self tapping screws were used
originally as in the door moulding trim, because this labor intensive
process would just be too slow for the assembly line!
A very minor point in a total restoration process, but a potentially
aggravating one when you get down to the final assembly stages.
Cheers,
Lin
1960 BT7 in restoration
1959 Bugeye
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|