I have been using Clevite # 216-1143 valve stem seals for years. They fit
right over the top of the stock valve guide and just barely fit inside the
inner spring.. I just bought some seals identical to the Clevite seals from
the local NAPA. For some reason, they could not get the Clevite seals, but
crossed-referenced to another brand (I think Fel-Pro) which were identical.
I think these seals are actually for a 2.8 L Chevy.
John Snyder
> After nearly going blind searching Google for valve guide seals I finally
> found a great information source on the topic at MGAguru.com. It's written
> by Barney Gaylord and is targetted toward MG owners, but the information
> applies to Healeys as well (the exploded drawing looks a lot like the one
> in
> the 100 manual.) In most cases the valve guides need to be machined to
> accept the seal, so doing it in-situ may not be possible.
>
> Brand names and sources you can look for are: Pioneer Inc. (RPM Machine),
> Simrit, Crane, Manley, Fel-Pro and 440 source. They provide a wide range
> of
> seals and I think I saw some that may not require the guides to be cut,
> but
> those may not fit inside the inner spring.
>
> Good luck.
>
> Bill Lawrence
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|