I just looked at the grille from my BN1-- pretty sure it's as original --
the tabs on the surround are fastened to the outer flange on the slat
assembly with very short (+/- 1/4") sheet-metal screws. Can't understand
why the tabs don't have holes in them.
Sarah Carr BN1 in PA
----- Original Message -----
From: <rrengineer@dslextreme.com>
To: <healeys@autox.team.net>
Sent: Sunday, July 01, 2007 5:13 PM
Subject: [Healeys] New 100-4 Grill Assembly
>I have a new 1004 grill assembly from Moss. It comes in two pieces, the
> cneter vertical slat assembly and the surround. It has to be assembled,
> but there are no instructions, screws, clips, etc. The surround has tabs
> welded to the back sticking straight back and the vertical slat assembly
> is supposed to be mounted to the surround centered using these tabs. I'm
> not sure if they are supposed to be bent over the slat assembly or drilled
> and tapped through to the two flat strips of the slat assembly. I don't
> have an original grill to look at, or know if they are assembled the same
> way. My body and paint guy needs the assembled grill t finish the front
> shroud opening before painting the car in the next few days. Anyone put
> one of these together in the past?
>
> Mike MacLean
> 56 BN2
> 60 AN5
_______________________________________________
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|