Oh! That's it. Thanks for the clarification.
Bill Lawrence
>From: "Rich C" <richchrysler@quickclic.net>
>To: "WILLIAM B LAWRENCE" <ynotink@msn.com>,<craigsuerice@iquest.net>,
><mlempert@bellsouth.net>
>CC: <healeys@autox.team.net>
>Subject: Re: BN1 Split Dash Question
>Date: Sun, 17 Jun 2007 00:42:06 -0400
>
>Bill,
>
>No, they are not the same at all. The filler valance panel to shroud is a
>solid black round section with a flat "tail", the tail pinching between the
>panels and slotted appropriately for the screws.
>
>The black moulding between the main fascia panel and instrument pod is the
>same section as the overrider to main bumper bar. It just needs to be
>slotted out on the inboard side for clearance where the weld tabs are on
>the instrument pod. These inside notches are not seen when assembled.
>
>Rich Chrysler
>
>----- Original Message ----- From: "WILLIAM B LAWRENCE" <ynotink@msn.com>
>To: <craigsuerice@iquest.net>; <mlempert@bellsouth.net>
>Cc: <healeys@autox.team.net>
>Sent: Saturday, June 16, 2007 11:48 PM
>Subject: Re: BN1 Split Dash Question
>
>
>>I re-used the old piece too, but I think the rubber strip is the same
>>profile as the one that goes between the lower front shroud and the the
>>filler panel behind the bumper.
>>
>>Bill Lawrence
|