I put a new front hub stub on today that I purchased from one of our
regular vendors. When I went to insert the old dust cap found it will
not fit in the stub. The ID of the new stub is smaller than the 47
year old original stub so the cap cannot go into its place. The vendor
suggested I grind down the outside of the cap which I have done to make
it smaller,but now I am getting to the point where I do not want to
take anymore off the cap. Has anyone else run into this problem and if
so whats the answer. Will the new caps fit into these new hubs. When
I did the other front one last winter had no problem.
Bill Pollock
59 BN 4
|