Following a paint job I want to fit the rear fender beadings on my
Healey 100 BN1. Having had a trial fit I came to the question how far
should the beadings go in the lower rear corner? Do they go full length
or do I need to cut them when they reach the rivited rear shroud lip,
where the lower corners of the inner fender panels meet the outer
fenders? Otherwise I need to twist the beading, which looks not very
nice. How was it done at the factory and is it done the same way at the
later 6 cylinder cars?
Many thanks,
Josef Eckert
Konigswinter/GERMANY
54BN1, 62BT7, 65Sprite
|