I'm certainly no expert in the area, but this is very different from what is
installed on my car (same vintage) Mine has two larger legs that are bent
almost 180 degrees around the bottom of the bumper. There are two crescent
fillers that fill the gap between the part of the plate that wraps around
the bumper and the curved part of the bumper. The plate where the license
attaches is larger than the one on ebay too. This looks to be either from
an earlier car(?), or is an after market one. It doesn't look like typical
british engineering.
Just my observation
Pete
-----Original Message-----
From: owner-healeys@Autox.Team.Net
[mailto:owner-healeys@Autox.Team.Net]On Behalf Of
mgtrcars@galaxyinternet.net
Sent: Tuesday, December 26, 2006 9:29 PM
To: healeys@Autox.Team.Net
Subject: License Plate Holder Ques.
There was a license plate bracket/and light on ebay for a BJ8. It doesn't
look complete to me, but the seller said it was.
Could some one knowledgeable about the BJ8 bracket please check these
pictures
out if they're still posted and let me know how that bracket attaches to the
rear of the bumper, and holds the plate in front of the bumper at the same
time.
Isn't something missing to make it work correctly?
I need one of these for my project and would like to get it right.
Thanks in advance, Mark
The auction number was 150072908448.
|