| To: | britishcars@shaw.ca, healeys@autox.team.net |
|---|---|
| Subject: | Re: FW: Cylinder Bore |
| From: | Warthodson@aol.com |
| Date: | Sat, 11 Nov 2006 08:12:23 EST |
Paul, Can a good block, one that passes the "sonic test", be bored out up to .204" without sleaving or is a sleeve required? I would be interested in hearing if anyone on this list has had their engine bored out close to this much. Say anything over .060" would be interesting to know about. Gary Hodson |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | heat insulation, Hartangus |
|---|---|
| Next by Date: | SU Carburetor Part, Ned Smith |
| Previous by Thread: | Re: FW: Cylinder Bore, Bob Spidell |
| Next by Thread: | Cylinder bore, Allyn Richardson |
| Indexes: | [Date] [Thread] [Top] [All Lists] |