This is one of the great mysteries. I tried several times to install
these things only to have them come loose and fall off. I've tried
silicone sealant (black) with poor results. I think the only solution
might be to devise a mechanical fastening method. Pop rivet? Sewing
thread? Any others?
Is there someone out there with the answer and would it be possible for
someone to post a picture of their installation (if any good solution
exists)?
Alan Schultz
67 HBJ8
Ned Smith wrote:
>My top does not have rubber end caps to finish the seals attached to the
>cant rails. I bought enough R and L caps to do the job but I don't see how
>they fit on the ends of the seals.
|