David -
To follow up on Jim's email -
You can use your existing Flywheel, it just needs to be re doweled from 2
pegs to three. Most competant flywheel surfacing shops can do this. The
bolt pattern on the clutch cover is the same. the other option is just to
get a lightened flywheel from bill bolton already prepared.
Alan
On 11/7/06, Bluechipracing <bluechipracing@snet.net> wrote:
>
> David: you will need the BJ8 flywheel, Pressure plate, clutch disc and
> throwout bearing.
>
> For the centre shift gearbox, If the car is presently a side shifter
> you'll need to fit the centershift fibreglass transmission cover and
> corrosponding carpeting....Don't know what mods are necessary for these,
> but
> it is probably straightforward. Other listers will have advice on this
> part.
>
> Jim
>
> ----- Original Message -----
> From: "D HALL" <dthall@btinternet.com>
> To: <healeys@autox.team.net>
> Sent: Monday, November 06, 2006 1:32 PM
> Subject: Clutch Modification
>
>
> > Good Evening
> > I am contemplating converting my 10" clutch on my BT7 to a 9" as per
> BJ8. The intention is to mate thee engine with a centre shift gearbox.
> Does
> anyone on the list have an appreciation of the task involved, if so would
> they please pass any relevant comments how best to accomplish the
> modification. David
> > BT7s MKI &MKII in boxes
> >
> >
> > David Hall
|