To: | "rjh" <rjh@hockertlaw.us> |
---|---|
Subject: | Re: Boot Lid Seal |
From: | John Loftus <loftusdesign@cox.net> |
Date: | Fri, 22 Sep 2006 11:31:31 -0700 |
Hi Jim, Simply look at the cross section of the seal. There is one 90 degree corner. This fits into the 90 degree edge of the boot lid (where the large inner surface of the lid meets the side return). This will orient the V (or hollow) toward the shroud. Also worth mentioning to put the start/end seam centered on the low side(by the lock)to help keep rain water out of the boot. Cheers, John ---- |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | RE: camshaft sprocket fitting, Norman Cay |
---|---|
Next by Date: | Re: Front Shroud, John Loftus |
Previous by Thread: | Re: Boot Lid Seal, David Nock |
Next by Thread: | RE: plug boots, Tom Felts |
Indexes: | [Date] [Thread] [Top] [All Lists] |