Dear Ed,
I have a Facet and SU setup, and have them on a radio remote control
(Circuit board in the Boot and key fob mounted below the carpet on the
tunnel) which I used to keep my Son, who is now more mature, from taking out
my BJ8. It allowed me to switch from one to another, or both off for
security. It has worked well for the last 5 years. The remote control
circuit was about $75.00. You can use a toggle switch to do the same
thing. I have seen someone mount it on the sheet metal below the rear
seats, but that is certainly not the only place to mount it.
I ran wires back from the SU and Facet back to the boot and that is where I
mounted the Circuit Board and fused wiring in a box.
Mark Goodman
66BJ8 35503
Date: Sat, 2 Sep 2006 16:18:10 EDT
From: EJBJR935@aol.com
Subject: Facet pump
I purchased a Facet today at NAPA for a back up (BJ8) and am now
considering
the best route for installation. It appears that it can easily be mounted
on
the bulkhead on the drivers side under the rear seat, with the fuel line
from the tank diverted to the Facet, then out of the Facet to the inlet of
the
SU., leaving the outlet of the SU intact. When the SU is working, it will
draw
through the Facet, and when the Facet is working, it will pump through the
SU. Will that work, or is there a better way? If a toggle switch is used
to
select one of the pumps for use, I would appreciate thoughts on the
location
of the switch and wiring instructions. Thanks to all. Ed Brennan
|