Alan: Thanks for the tip. The 100 master cylinder is cast iron.
Jim
----- Original Message -----
From: "Alan Schultz" <alan@andysnet.net>
To: "Bluechipracing" <bluechipracing@snet.net>
Cc: <healeys@autox.team.net>
Sent: Thursday, August 10, 2006 10:35 PM
Subject: Re: Bleeding brakes, BN2
> It has been stated many times that honing an aluminum cylinder will not
> work. Is your master cylinder aluminum? It should have a sleeve
> installed then honed.
>
> Alan Schultz
> 67 BJ8
>
>
> Bluechipracing wrote:
>
>>I just rebuilt the master cylinder on my BN2. Honed the bore and
installed
>>rebuild kit....all new rubber etc. Now I'm bleeding the brakes, and I
can't
>>seem
|