You installed the 3/4 sliding hub in the wrong position on the main
shaft. There is a small plunger inside the gear that goes into a
notch in the main shaft. If the gear is installed in the wrong
position it will not go into high gear.
You will need to strip the transmission to take the 3/4 sliding hub
off the main shaft and install in the correct position.
David Nock
British Car Specialists
Stockton Ca 95205
209-948-8767
www.britishcarspecialists.com
.
.
On Jun 21, 2006, at 7:27 AM, Ned Smith wrote:
> The good news. The drive train is back together ( bell housing,
> gear box,
> and OD), filled with oil. No leaks.
>
> The bad news. I cant shift into 4th gear. All other shifts work
> well but
> the 4th 3rd selector fork moves only < forward and then seems to
> hit
> something. Rotating the input shaft doesnt help.
>
>
>
> I really dont want to take this all apart again.
>
> Your suggestions are greatly appreciated,
>
>
>
> Ned Smith
>
> BJ8
|