John,
As a last resort you can drill down through the top of the brass
fitting in line with the fuel feed pickup pipe. You could then run
some solvent down the pipe or ram the screen if needed. I cleaned
mine this way. To plug it, tap the hole to 1/4-20 thread (check this
size before drilling); solder a brass plug in place to plug the hole;
contour file the plug and you are done. BTW, I filled the gas tank
with water while doing all of this.
John
At 07:16 PM 6/2/2006, John Snyder wrote:
>Hello List,
>
>Any ideas? I hate to cut into the tank to remove the screen.
>
>John Snyder
|