| To: | <healeys@autox.team.net> |
|---|---|
| Subject: | 100S Dash Question |
| From: | "John Rued" <rudedoggg@earthlink.net> |
| Date: | Mon, 1 May 2006 22:01:32 -0500 |
To the few 100S experts out there, I have a question. I would like specific dimensions--referenced to a constant point--to locate a hole for an oil temp gauge. Can anyone devise an "x-y" (over-and-up) coordinate system from an obvious reference point for an early, two-piece dash? Thanks, John Rued 53BN1 |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: replacement frame, John Rued |
|---|---|
| Next by Date: | trans question, James Shope |
| Previous by Thread: | Carrosserie Demola special, Larry Varley |
| Next by Thread: | Re: 100S Dash Question, Greg Lemon |
| Indexes: | [Date] [Thread] [Top] [All Lists] |