Greg -
If you jacked the car up, then set it down without rolling, you will
get too much positive camber by looking at it.
Take it to a shop and have them check toe-in toe-out and camber.
If camber is in fact a problem make sure you have the right shock arms
on your car. If so, then your best bet is to replace the shock mount
plate with the adjustable shock mount plate available from Kilmartin,
cape, BCS, or Dennis welch. it will cost a bit to replace, but it
really is a good set up.
Best Regards,
Alan
'53 BN1 '64 BJ8
On 4/6/06, Greg Lemon <glemon@neb.rr.com> wrote:
> Sorry, I don't know what I did worn but I rechecked on the camber and it
> doesn't seem to be anywhere near as far off as I had indicated, I will
> probably take it to a good suspension alignment shop that can do more accurate
> measuring than I and see what they say.
>
> Greg Lemon
> 54 BN1
|