When getting the kit, you should also buy an ALI rear engine plate -
it will make the whole job easier because you won't have to cut the
current rear engine plate, which is steel. In addition the Ali plates
are much lighter, saving engine weight. I would recommend the round
kit that cape sells, although the square kit DW sells is probably
fine.
Cheers,
Alan
'53 BN1 '64 BJ8
On 3/4/06, Tom Syperski <tom.syperski@sev.org> wrote:
> We have started and driven my '67 BN-7 after 23 years in storage. Runs
> and sounds great.
>
> Oil is dripping from the small hole in bottom of bell housing.
>
> This should be solved with a rear crankshaft oil seal kit.
>
> What are your suggestions regarding the various kits available?
>
> Any advice on installing without pulling the engine?
>
> Tom
> '61 BN7
|