Hi Mirek
Most OEM mains and big end bearings are usually made of a composite
of three metals rarely two; others for racing are a lot more complex. I
ordered mine from SC Parts but this was prior to their take over. They
or Steve Jowett at UK Healey should able to help. If you are close to Bob
Yule's location you could drop in and ask him.
Kind regards
Ed
Saskatoon
Mirek & Gwen Sharp wrote:
> Hello all,
>
> I have been shopping around looking for the original tri-metal bearings that
> were fitted to out Healeys. Preferably I would like to use the original
> Vandervell bearings, but I would be satisfied with AE, as long as they are the
> tri-metal type.
>
> I have tried the usual sources for A-H parts (Moss, A-H Spares, Cape
> International, British Car Specialists, etc.) but with little luck. I will
> cave in and use the King Bearings sold through County if need be, but if there
> is a set of Vandervells lurking on shelf somewhere, I would like to find
> them.
>
> I am looking for +0.010" over mains and rods.
>
> cheers,
>
> Mirek
> '60 BT7
|