Bob and Betty Frisby wrote:
> I'm installing a new fusebox on my .'62 BT7 tri-carb. It is a "Buss"
> product, and takes up to 10 blade-style fuses. I'm separately fusing
> each of the following circuits, based on wires available at the
> fusebox location: (1) fuel pump, (2) O/D relay, (3) fuel gauge and
> heater fan, (4) wipers, (5) turn signal switch, (6) turn signal
> flasher, and (7) brake lights.
Two other items need to be fused. Horms and rear license plate light.
Fuse sizes should be such that the wiring will not overheat and melt.
Depends on wire gage and insulation type. My guess is to use 15 amp for
items (1), (2), (3), (4) and horns. 10 amp for the rest.
Maybe someone on the list could verify?
Alan Schultz
HBJ8 (Thinking about adding more protection)
|