The pins are not hardened as far as I known. I had to use a sawsall to cut
three of the four pins on my BN7. There was just no other way to get them
out. Be careful you don't cut into the
side brace. I used a very long blade in my sawsall to give me some more
room to work the saw.
Good Luck
Ron
Last night I spent three hours trying to remove the fulcrum pins in my BN7.
I tried beating them. I tried heating them. I tried heating and beating
and beating and heating. All I have to show, is a very sore shoulder.
Whats the secret?
Unless someone has a better idea, my next attempt will be to try to cut
through the pins on each side of the "A" arm with a sawsall. Are these pins
hardened? That would make using a saw quite difficult.
I'm sure that I am not the first one to experience this problem. Any
succesful solutions are greatly appreciated.
|