Ron,
There were usually 4 no. 8 x 1" self tapping phillips or posidrive head
screws going down each side lip of that extension panel, through the
carpet(see picture att'd.) Also the original parts book calls for 2 per each
side no.8 x 3/4" self tapping phillips or posidrive head screws through the
metal only, holding the bottom lip to the floor/chassis.
Hope this helps.
Rich Chrysler
----- Original Message -----
From: "Ronald A. Fine" <ronfineesq@earthlink.net>
To: <healeys@autox.team.net>
Sent: Friday, November 11, 2005 4:27 PM
Subject: fiting gearbox cover extension panel
> Sorry to boor the list with such a mundane question, but, I am refitting
> the "extension panel" that goes against the firewall covering the front of
> the transmission and bell housing. Moss catalog shows screws in the
> bottom flanges on each side into the floor or frame. Are there any other
> screws used to attached it to the firewall directly, at the sides or top
> through the carpet? (Ed, I've looked at all my books and every photo I
> can find but the detail doesn't show!)
> Thanks,
> Ron
> BN7
[demime 1.01d removed an attachment of type image/jpeg which had a name of
60003.jpg]
|