Hi Jim,
After placing the Dynamat where I wanted it, I used a heat gun to soften the
butyl a little. Then use a rubber roller similar to this one
http://www.joann.com/catalog.jhtml?CATID=113731&PRODID=113621&source=search
to get it to form to the floor. I also used some aluminum tape along the
seams to keep the butyl from harassing the jute.
-----Original Message-----
While at the Street Rod Nationals today (300 parts vendors and 11,000 cars)
I
stopped by the Posie's booth and they were promoting Dynamat Extreme with a
car show special of $225 for the 36 sq. ft kit. A little haggleing about it
being the final hours of the show etc and they sold me the last kit for
$150.
Any tips on how to install this? I have the transmission out for a clutch
change so the interior is basically bare.
Thanks,
Jim Werner
Louisville, KY
|