Hi Michael and Ray
Michael your comment seems to be bang on regarding dimensions. The guide
that Roger Moment produced for Anderson and Moment provides only an
index to type and finish; the booklet prepared by Todd Clarke based on
a "parts information bulletin" from BMC provides dimensions of various
fasteners for the day. But still missing is the marriage between the Parts
manuals and dimensions. That is unless our resident author in Kurrajong
Heights, NSW, or the Black and White Healey maven might have this
ethereal data source.
Kind regards
Ed
Saskatoon
Michael Salter wrote:
> Hi Ray,
> As far as I have been able to determine there is no correlation between the
> part numbers for the earlier fasteners and their dimensions.
> As I understand it the part number refers to the drawing number for the part
> and these were allocated randomly.
> I hope someone knows otherwise because, as you suggest, it would be a big
> help.
>
> Michael Salter
> www.precisionsportscar.com
>
>
> -----Original Message-----
> From: owner-healeys@autox.team.net [mailto:owner-healeys@autox.team.net] On
> Behalf Of Ray Juncal
> Sent: Monday, June 20, 2005 5:39 PM
> To: Healey list
> Subject: fasteners & part numbers
>
> I have the official parts book and the list of codes used for UNF
> fasteners. With that the three letter and four didgit part number in the
> book
> can be translated into type,size, length and finish of any fastner listed.
> Example (HZS 0506) That works fine for BN-2 thru BJ-8.
> Is there any way of extracting similar information from the part numbers
> for the BN-1? They would be BSW, BSF or BA as they were before the switch
> to
> "Unified Thread Size"on or about 1955. Those part numbers are one didget
> one
> letter followed by three or four didgets (2K 3092 or 7H6701) If there is
> any
> logic to these numbers some of you guys must have figured it out and I sure
> could use the information.
>
> Help me Obiwan you're my only hope!
> Ray Juncal
> Toot toot!
>
> PS; Here's to HOYO where ever you are. Healey on.
|