I am in the process of putting my car back together after body and paint
work, and can't quite figure out how the dip switch wiring harness
fits. When I took my car apart the entire harness had been badly
patched and the before pictures are of no help.
I have taken lots of pictures of other cars, looked at several books and
am still confused.
Rich Chrysler sent me a picture showing how the setup looks in the
footwell. So I gather the wire runs up through the hole in the flat
panel left of the clutch pedal. The connections for the dipswitch
wiring are at the Y area of the main harness where one section passes
through the firewall, one section goes to the left and the other to the
right. I assume the dipswitch wiring runs over the top of the flat
panel near the flasher unit and along under the fuse box and overdrive
relay and throttle switch. But I can't tell from the pictures I have seen.
Would someone let me know how this works.
Thanks,
Larry Swift
|