Ditto
tom
> [Original Message]
> From: BJ8Healeys <sbyers@ec.rr.com>
> To: <healeys@autox.team.net>
> Date: 5/30/05 9:38:36 AM
> Subject: Re: Silicone Brk. Fluid
>
> Not having the benefit of the list wisdom at the time I converted to
silicone
> in 1989, I just flushed the system with a couple bottles of rubbing
alcohol
> (mostly to remove any water present), and charged the system up with
silicone.
> I didn't change any seals or other components, and I never had any
problems,
> at least that I could relate to silicone. My brake booster did fill up
with
> fluid several years later, but all the other brake components on the car
are
> the ones that were there during the conversion.
>
> No idea why some have problems and some don't. If I had known about
potential
> problems with seals, I probably would have changed mine as well, as a
> precaution.
>
> Steve Byers
> HBJ8L/36666
> BJ8 Registry
> Havelock, NC USA
>
>
>
>
>
> ----- Original Message -----
> From: Mark and Kathy
> To: healeys@autox.team.net
> Sent: Monday, May 30, 2005 9:05 AM
> Subject: Re: Silicone Brk. Fluid
>
>
> In my findings the consensus has been to replace ALL rubber seals.
This is
> a decision best done after a complete brake job, including rubber seals.
>
> You can just flush the system and it may work for awhile, but chances
are it
> will create problems down the road.
>
> My experience was that the silicone tended to cause the rubbers to swell
> excessively when I just flushed the old system. The wheel cylinders
became
> too firm with VERY HARD brake peddle. Only the front disc brakes were
> working. So instead of improving my braking it made things much worst.
>
> I have run silicone in many of my cars and have had good results also.
I
> suggest that you use a well know companies product and change ALL your
> rubbers and it should last for a long time. Remember that this stuff
costs
> twice as much as Dot 4 so one leaky seal is money down the drain.
>
> And as I have mentioned on the list before, silicone will also swell the
> seals in an Easy Bleed system over time and makes the seals unusable.
I
> learned that the hard , expensive way.
>
> MARK
> ----- Original Message -----
> From: "Allen C Miller, Jr." <acmiller@mhcable.com>
> To: <healeys@autox.team.net>
> Sent: Monday, May 30, 2005 4:30 AM
> Subject: lubricants
>
>
> > Thanks for the several replies on this thread
> >
> > If I should go to the silicone brake fluid, how do you convert from
> > conventional fluid to silicone? The reservoir is empty, but I have
> regular
> > brake fluid in the lines. Can you just displace the DOT3/4 by filling
and
> > bleeding in the correct order until you've cylced through a certain
amount
> > of
> > new silicone fluid? Or do you have to flush out the lines?
|