The corner screws (two each side) are zinc plated round head Philips screws.
they are 10-32 thread and have no washers on the visible side.
Ken Mason
BJ7 in work
----- Original Message -----
From: Richard Bittmann<mailto:edmyed@harbornet.com>
To: Tom Blaskovics<mailto:u2347@wvnvm.wvnet.edu> ;
healeys@autox.team.net<mailto:healeys@autox.team.net> ; Peter
Braun<mailto:peter.braun@minifairfieldcounty.com> ; Rich
C<mailto:richchrysler@quickclic.net> ; davidwjones<mailto:davidwjones@cox.net>
; Roger Moment<mailto:Rmoment@comcast.net> ; John
Snyder<mailto:helyjohn@cablespeed.com>
Sent: Friday, May 13, 2005 10:42 PM
Subject: BJ7 Dash Screws
BJ7 Officianados:
I know there was a discussion on this subject recently where you answered
that
the corners of the dash were secured with chrome plated raised head
countersunk finish screws in cup washers but I found these screws holding
my
dash when I disassembled it. My car had it's dash recovered in the
mid-late
seventies by me and I just want to make sure that these screws aren't
original
be for I toss them. Thanks for you reply in advance. Richard Bittmann BJ7
Tacoma
[demime 1.01d removed an attachment of type image/jpeg which had a name of
P5130001.JPG]
|