John,
Robb at British Tool manufactures and sells the socket you need for the rear
axle nut (an eight sided nut):
http://www.britishtool.com/servtool.htm
Item BT2 $40. The socket for the 100 is BT1, also $40.
Bob
glembotski@sbcglobal.net wrote:
> I have seen this discussed before but what size socket is required to remove
> the subject nut from a BJ8 axel? Also the manual describes the tool to
> reinstall the hub to the axle housing as a circular drift. It appears to be a
> length of steel tubing. Does anyone know the ID of the tubing required, and
> where some length of this can be obtained. Thanks in advance
>
> John G.
> 67 BJ8
|