Rich, could you email me the photos that were stripped from your response
to Patton? I will start the interior of my BN7 in a few weeks. The prior
owner removed the original dash pad so I need to recreate one without the
benefit of the original to use as a guide. I've looked at most of the books
I have but there doesn't seem to be much information on how the dash pad is
installed originally. Any help (photos etc?) would be greatly appreciated.
Thanks,
Ron Fine
----- Original Message ----- >
> No, the complete dash cowl pad is installed onto the top surface and is
> held
> there by one #6 trim screw with cupped washer at each side, 1 turnbutton
> fastened into place with two #6 trim screws, the two 10-32 screws also
> holding the dash mirror down through into welded nuts under the dash, and
> the long shank tenax stud just to the right of the mirror. Of course all
> this is installed before the windscreen assembly so you can get access to
> the screws near each corner.
> See pictures att'd. (Yeah, I know, the rest of the list won't get 'em.)
|