Great Bob. Thanks!!!
>From: "Bob Spidell" <bspidell@comcast.net>
>To: "scott willis" <ahpowered@hotmail.com>,<healeys@autox.team.net>
>Subject: Re: Petronix Ignition? Do I need rev limiter?
>Date: Fri, 29 Apr 2005 20:33:35 -0700
>
>Scott,
>
>I don't believe any Big Healeys used a ballasted ignition system (I know
>the
>BN2s and BJ8s don't, and I don't see any resistor listed in the Moss
>catalog
>for any 100-6 or 3000). If you had a ballasted system, there would be a
>big,
>ceramic wound-wire resistor somewhere in the primary ignition circuit.
>
>I believe Pertronix states that the coil should have 1.5 ohms of
>resistance. Theoretically, any coil that meets this requirement would
>work; however I'd
>buy the Pertronix coil just to be sure. But--this will probably start a
>flame war--I
>don't think there's a need for "performance" coils in an otherwise stock
>Healey engine. If fact, you're more likely to get more trouble from the
>extra voltage
>leaking through the distributor cap and spark wires than you'll get benefit
>from a high-voltage coil (which are mostly used in very high-revving and
>high-compression engines, with upgraded ignition components). I put a
>Pertronix in my BJ8 with the stock coil and the engine starts quicker,
>idles smoother and more consistently and revs up to redline with no
>hesitation--what more can you ask for?
>
>Pertronix doesn't require a rev-limiter. I don't think one is necessary;
>Healey
>engines aren't high-revving by nature ... you'd have to be pretty remiss to
>over-rev a Healey to the point of doing damage.
>
>IMO
>
>bs
>***************************************************************
>Bob Spidell San Jose, CA bspidell@comcast.net
>'67 Austin-Healey 3000 '56 Austin-Healey 100M
>***************************************************************
>
>
>>OH yeah, is my system non-balasted? Uh...der...duh...
>>
>>>From: "scott willis" <ahpowered@hotmail.com>
>>>Reply-To: "scott willis" <ahpowered@hotmail.com>
>>>To: healeys@autox.team.net
>>>Subject: Petronix Ignition? Do I need rev limiter?
>>>Date: Fri, 29 Apr 2005 21:35:09 -0500
>>>
>>>Gents,
>>>
>>>I plan to order the Petronix ststem for my 60 BN7. I changed polarity to
>>>neg. ground. I plan to order Moss part 222-571 Igniter for Lucas Model
>>>DM6 distributor. I also plan to order Petronix coil 143-265. Will any
>>>40,000 volt coil work such as P-40511 Flame Thrower?
>>>
>>>Is there anything else I need for the system?
>>>
>>>Thanks for any thoughts.
>>>
>>>Cheers,
>>>Scott
>>>Mashed BN7
>
_________________________________________________________________
Dont just search. Find. Check out the new MSN Search!
http://search.msn.click-url.com/go/onm00200636ave/direct/01/
|