Sid,
I to had to apply more pedal pressure than I am used to before the brake
lights came on. The hydraulic switch was replaced with new. I installed
a switch (in parallel with the hydraulic switch) which is actuated when
the brake pedal is pushed about 1/2 inch from normal at rest position.
I installed a small bracket at the pedal to hold the switch. Any auto
supply store will have switches of this type. Remember to buy a normally
open type switch.
Alan
67BJ8
Sid Bronson wrote:
>I seem to have to apply an inordinate amount of pressure on the brake pedal to
>light the brake lights. I have rock hard pedal with good braking and a new
>hydraulic brake switch and new servo. At times when holding firm pedal the
>lights come on then go off. Any suggestions? Has anyone converted to a pedal
>actuated switch ?
>Sid 65 BJ8
|