Hi Alan,
Oil gallery repair kit.
There IS such a thing. In theory it should work. Whether it does work or
not, I will leave up to someone with experience in the matter. It would
be quite difficult to find the leak, & I think, a pretty expensive
repair. I don't know what "radiator repair solutions" has to do with the
discussion. Please explain?
A quote from the Moss catalog:
"Cylinder Block Oilway Repair Kit"
"Many Austin-Healey engine blocks suffer from internal corrosion between
the oil galleries and water passages which causes leakage of oil into
the cooling system. To remedy this, the affected oil galleries can be
drilled out and lined with stainless steel tubing by using this kit. (We
do recommend that the drilling of the block be done professionally.) Kit
includes stainless steel tubing, installation tools, replacement oil
gallery plug with copper washer, & full instructions."
Dave Russell
Blue One Hundred wrote:
> Bill -
>
> You have a 99.9% chance that your head gasket is bad. Since oil is
> only going one way into the oil, I would suspect that one of your
> cylinders would be running low compression (but not always the case).
> A Compression check will confirm it.
>
> The other 0.1% chance is either your head or block has developed a
> leak. This of course would be very expensive to fix... likely
> involving a welder or resleaving.
>
> There is no such thing as a repair kit to fix oil getting into your
> water, and if Moss is advertizing such a thing, the should be told
> not to do this. Radiator repair solutions can only be used to fix
> water leaking out of a radiator, or water leaking into your oil...
> not the other way around. And even at that, this type of fix is a
> chicken sh*t way to fix your healey.... and can cause a myriad of
> other problems such as overheating.
>
> Sounds like to me you have to take the head off your car and replace
> the head gasket. Retorquing the head won't fix this type of problem.
> While the head is off, you should get a valve job and rebuild your
> rockers.
>
> Cheers,
>
> Alan
>
> '53 BN1 '64 BJ8
>
> On 4/14/05, INSPTWO@msn.com <INSPTWO@msn.com> wrote:
>
>> Hopefully, I am not the only one this has happened to. I seem to
>> have developed a leakage between the oil galley and the water
>> jacket. I have oil in the water and not the other way around. I
>> note that M*** has a repair kit available for this, so I can't be
>> the only one to have this happen. Hopefully, and regretably,
>> someone on the list has gone thru this !!@#$%^&* problem. Please
>> contact me as I REALLY need some advice. Thanks, Bill BJ7
|