Michael,
The pipe runs down immediately in front of the left engine mount and aims
inboard of the frame member. The P clip anchors to the upper bolt that
passes horizontally forward from the top of the engine mount bracket through
the front engine plate. Washer and nut goes on from the front. The flexible
fuel line goes from the steel line clipped from the left lower inboard
chassis rail and does a gentle curve 90 degrees up to the above fuel pipe.
This carb fuel pipe was originally hand painted a dull silver at the
factory.
Hope this helps.
Rich
----- Original Message -----
From: "Michael Williams" <mewilliams@comcast.net>
To: <healeys@autox.team.net>
Sent: Sunday, April 03, 2005 12:06 PM
Subject: 100 Hard Fuel Line Routing
> Everyone,
>
>
>
> I have refitted the carbs to my BN1. I have acquired an original
> carb-to-carb fuel line to replace the non-original one that was installed.
> I
> can't figure out what route the pipe from the front carb is supposed to
> take
> down to the petroflex hose. The way this one is currently bent it would
> appear to want to go right down the middle of the engine mount - but this
> does not seem right. Also, I need to know what the p-clip on the down pipe
> is supposed to attach to.
>
>
>
> Thanks,
>
>
>
> --Michael
>
> '55 BN1
|