Re: Stripped Thread

[Drtrite@aol.com]

In a message dated 3/27/05 7:15:47 AM Pacific Standard Time, 
tpmul@worldnet.att.net writes:
I was bolting up the clutch slave cylinder and
the threads in the top hole stripped. It's a 3/8 fine thread bolt
Hi Tom,

Check with a local fastner supply company and tell them what you need. I 
think Loctite makes a product that you can use. You put  compound in the hole 
and 
then after putting a release agent on the bolt you assemble it. I am not sure 
wnat the specs are as far a strength.

Don