james,
before doing this, check out tech tip #5 on the north tx ah club site
www.ntahc.org
a speedi-sleeve may save you a lot of work.
happy healeying,
jerry wall
James Sailer wrote:
>
> Greetings all.. Am in need to pull my timing cover off to replace seals ...
> Two questions:
>
> 1. What is the proper size of the wrench/spanner to fit the crankshaft nut?
> (66 BJ8)
> 2. Do I have to jack the motor up to remove the crank nut and pull the
> pulley/damper to perform this work or is there enough room without raising?
> (or how much raising is needed?)
>
> Thanks much for your help...
>
> Jim Sailer 66 BJ8 - correcting odds and ends after my resto ...
>
> Your messages not reaching the list?
> C
|