My only comment is that if your BN7 is a tri-carb, be very careful of the
clearance between the bottom of the rear carb jet (plastic) and the steering
column.
John Snyder
> Hello. I have a question about positioning the engine and transmission in
> my chassis. I reinstalled my engine and transmission as one unit this
> morning. I haven't tightened up the bolts yet because there seem to be a
little room for adjustment of the engine side to side and if you grab the
transmission output shaft you can swing the whole system left or right
almost 2 inches. Is there a method or guide to aligning the engine and
transmission laterally in the chassis?? Any advise is always appreciated.
> Ron
> 61BN7
|