I just replaced the wheel cylinders and brake hoses on my BN1. I also rebuilt
the master cylinder.
With everything reassembled, I can't get any fluid into the system. I have
pumped on the pedal with a bleed plug loose, but to no avail. I hooked up a
suction device at a wheel cylinder and created 20 psi vacuum, but it doesn't
draw any fluid either.
Perhaps I screwed up the master cylinder rebuild, but I don't think so. I
did, however, neglect to bench bled the master cylinder before I installed it,
but it seems that would not be insurmountable. Any suggestions on how to get
fluid into the system and bleed it? Is there a cap adapter so one can
pressurize the fluid reservoir?
Many thanks,
Ben
54 BN1
|