I tapped in a suitably-sized brass plug with JB Weld around the
edge. It's held for probably 15-20K miles.
bs
********************************************
Bob Spidell San Jose, CA bspidell@comcast.net
'67 Austin-Healey 3000 '56 Austin-Healey 100M
********************************************
----- Original Message -----
From: "Mark and Kathy" <mgtrcars@galaxyinternet.net>
To: <healeys@Autox.Team.Net>
Sent: Sunday, December 19, 2004 5:34 PM
Subject: Manifold casting plug
> What is the best way to handle this casting plug as far as preventive
> maintenance. Is there a contemporary permanent fix for this plug that
> someone can suggest? Since this a bit of a heat generated area I assume that
> a little more than a new plug and Hylamar is necessary?
>
> Thanks , Mark
>
> Your messages not reaching the list?
> Check out http://www.team.net/posting.html
|