The claims I have heard about the Henrob (or Cobra) have made it sound
great. They claim that it cuts like a Plasma Cutter, welds like a
TIG.
A cheap MIG is less money, but its about the same cost a Lincoln or a
Hobart MIG. Is it that good? If you only had ONE welder to learn and
use, would it be your choice?
Patton
On Wed, 15 Dec 2004 11:48:31 -0800 (PST), Jackson Krall
<jackson_krall@yahoo.com> wrote:
> Instead, I have stayed with the oxy/acct. I have been
> using the low pressure Henrob torch and am very
> satisfied. Total portability, low distortion, low
> pressure means small tanks last longer, heat for
> busting rust and bending/forming/cutting. I think this
> is the way to go.
--
Patton Dickson - Richmond, TX
'57 A-H 100-Six - http://Austin-Healeys.com
|