The grease cup thread on the front hubs is 5/16th fine or coarse Ii
don.t remember but you can look and see. It is easy enough to construct
a puller from parts at your local hardware store. I do have a tri-carb
question, Linkage disconnected, each jet set at 2 turns , warmed up,
first and third carbs will balance, second carb has vacuum off the scale
on the carb sycroniser with the throttle closed. Cylinder in second carb
will not remain closed with engine running. I have removed the carbs and
checked for any possible vacuum leaks with nothing found. Could this be
a jet mixture problem, or perhaps replacement of the jets is necessary,
jet seats have been replaced and the jets centered kurt L
|