Dave,
There is one big nut holding the rotor/hub assembly--and bearings,
of course--onto the spindle. Just remove the caliper, the nut and pull ...
There's two sets of tapered bearings, (should be) a spacer and some
shims in the hub ... check the archives for numerous posts about the shims.
bs
********************************************
Bob Spidell San Jose, CA bspidell@pacbell.net
'67 Austin-Healey 3000 '56 Austin-Healey 100M
********************************************
----- Original Message -----
From: "Dave Leland" <starofindy@yahoo.com>
To: <healeys@Autox.Team.Net>
Sent: Saturday, November 06, 2004 2:00 PM
Subject: Brake Rotor removal
> Hi Everyone- is there a trick to removing the brake
> rotors?
>
> It's a BJ7 and this is my first car equipped with wire
> wheel hubs. Thanks in advance.
>
> Dave Leland ('63 BJ7)
> Nashville, TN
|